Determining Loads With Bench-Rest Testing

After setting up the testing conditions, test a variety of loads by firing a series of three shots with each load. If possible, try a variety of bullet and powder combinations. The combination that gives you the best grouping on the target should be your selected hunting load.

Follow these guidelines when loading a powder charge.

• Usually firearms are most accurate at 70–90% of maximum load.
  • A load less than that reduces velocity, increases trajectory, and allows other variables, such as wind drift, to influence the shot.
  • Greater loads burn partially and unreliably, diminishing accuracy without adding benefit.
• The ball with a patch generally accepts higher powder charges more safely than large conical bullets.

Refer to your manual for minimum and maximum loads. Also, some states require a minimum caliber for certain game. Be sure that you meet these regulations. To select a starting load:

• Start with half of the maximum load or…
• Load an amount of powder equal in grains to the firearm’s caliber.

Focus on accuracy factors to find the perfect load.

• Vary the tightness of the round-ball patch.
  • Try different thicknesses and different patch materials.
  • Examine spent patches for holes or charring that may indicate you need to use a different material or loading technique. In general, patches that are charred were too thin and allowed gases through.
• Consider using tightly fitting conical bullets, which are often, but not always, more accurate.
• Keep your ignition system functions consistent.
  • On in-line and percussion lock firearms, use the same brand of cap.
  • On flintlock firearms, use the same way of fitting the flint and priming.
• Narrow down the best load combinations, and then try slight variations to see if any can be improved further.
• Analyze what may be the most consistent weaknesses to improve load performance.